1 1/2 in Diamond Core Bit Rental in Brooklyn, NYC
The 1 1/2 in diamond core bit cuts a round hole about 1 1/2 in across through concrete, block, brick and stone on a core drill. It has 4 diamond teeth and a 15 3/4 in overall length. Rent it from our Brooklyn yard at 181 2nd Ave, or have it delivered with your drill anywhere in the five boroughs. Call 718-344-1474.
1 1/2 in core bit for a gas line to a backyard grill
A Bay Ridge homeowner wants a built-in gas grill on the patio, fed from the meter in the cellar. Gas pipe that passes through a foundation wall goes inside a protective sleeve. The plumber runs 1/2 in black steel gas pipe (0.840 in OD) inside a short 1 in Schedule 40 steel sleeve. The sleeve is 1.315 in on the outside, so a 1 1/2 in core leaves about 3/32 in each side, a snug fit for setting the sleeve in sealant or mortar. The gap between the gas pipe and the sleeve gets sealed too, so water and gas cannot travel along the pipe.
Before you start: Gas work in NYC is done by a licensed master plumber. Rent the bit for them, or tell us the plumber’s sleeve size and we will match it.
Is 1 1/2 in the right size?
Measure the outside of the pipe, duct or sleeve that has to fit, not the size printed on it. Then leave room for sealant, grout or firestop around it. In the job above, that works out to about 3/32 in each side.
- Bigger pipe or duct? Try the 1 3/4 in diamond core bit. Its usual job: feeder to a new sub-panel (1 1/4 in EMT conduit, 1.510 in OD).
- Smaller pipe or duct? Try the 1 1/4 in diamond core bit. Its usual job: AC condensate drain through a concrete wall (3/4 in PVC, 1.050 in OD).
- See every size and what it fits in our core bit size chart.
Specifications and Features
Rental Details
Which drill: this size runs on the EDCO handheld core drill for walls and tight spots, or on a 36 in core drill rig for floors. Already have a drill? Tell us the model when you request a quote and we will check that the bit fits it.
Drill wet. Keep water running to cool the bit and keep silica dust down, and read the OSHA guidance on crystalline silica before you start. Scan slabs for rebar, conduit and post-tension cables before you core a floor.





