4 1/2 in Diamond Core Bit Rental in Brooklyn, NYC
The 4 1/2 in diamond core bit cuts a round hole about 4 1/2 in across through concrete, block, brick and stone on a core drill. It has 9 diamond teeth and a 15 3/4 in overall length. Rent it from our Brooklyn yard at 181 2nd Ave, or have it delivered with your drill anywhere in the five boroughs. Call 718-344-1474.
4 1/2 in core bit for a dryer vent
A Ditmas Park family moves the laundry into the basement, and the dryer has to vent through the concrete foundation wall. Dryer vents are 4 in rigid metal duct, and the wall cap’s tailpiece is the same size. A 4 1/2 in core leaves about 1/4 in all around to slide the duct through and seal it. Plain 4 in is too tight to fit the duct without forcing it.
Tip: Put the hole where the duct run stays short and straight. Dryer vent length is limited, and every elbow counts against it, so check the limit in your dryer’s manual.
Is 4 1/2 in the right size?
Measure the outside of the pipe, duct or sleeve that has to fit, not the size printed on it. Then leave room for sealant, grout or firestop around it. In the job above, that works out to about 1/4 in each side.
- Bigger pipe or duct? Try the 5 in diamond core bit. Its usual job: waste stack through a floor slab (4 in no-hub cast iron, 4.38 in OD).
- Smaller pipe or duct? Try the 4 in diamond core bit. Its usual job: concrete test core for an engineer (takes out a core just under 4 in across).
- See every size and what it fits in our core bit size chart.
Specifications and Features
Rental Details
Which drill: this size runs on the EDCO handheld core drill for walls and tight spots, or on a 36 in core drill rig for floors. Already have a drill? Tell us the model when you request a quote and we will check that the bit fits it.
Drill wet. Keep water running to cool the bit and keep silica dust down, and read the OSHA guidance on crystalline silica before you start. Scan slabs for rebar, conduit and post-tension cables before you core a floor.





