2 1/2 in Diamond Core Bit Rental in Brooklyn, NYC
The 2 1/2 in diamond core bit cuts a round hole about 2 1/2 in across through concrete, block, brick and stone on a core drill. It has 6 diamond teeth and a 15 3/4 in overall length. Rent it from our Brooklyn yard at 181 2nd Ave, or have it delivered with your drill anywhere in the five boroughs. Call 718-344-1474.
2 1/2 in core bit for stoop railing posts
The iron railings on a Bed-Stuy brownstone stoop have rusted through at the base, and the new railing has 1 1/2 in steel pipe posts (1.900 in OD). Each post gets a 2 1/2 in core about 4 to 5 in deep into the stoop. That leaves about 5/16 in all around for non-shrink anchoring cement, enough to set the post plumb and lock it in. The same bit works for 1 1/2 in square tube posts: the corner-to-corner width is 2.12 in, which still leaves room for cement at the corners.
Tip: Core every post hole before you set any of them, then dry-fit the whole railing. It is much easier to fix a hole than a post that has already been grouted.
Is 2 1/2 in the right size?
Measure the outside of the pipe, duct or sleeve that has to fit, not the size printed on it. Then leave room for sealant, grout or firestop around it. In the job above, that works out to about 5/16 in each side.
- Bigger pipe or duct? Try the 2 3/4 in diamond core bit. Its usual job: ductless mini-split line set (line set, drain and cable bundle in a wall sleeve).
- Smaller pipe or duct? Try the 2 in diamond core bit. Its usual job: sprinkler branch line through a block wall (1 1/4 in steel pipe, 1.660 in OD).
- See every size and what it fits in our core bit size chart.
Specifications and Features
Rental Details
Which drill: this size runs on the EDCO handheld core drill for walls and tight spots, or on a 36 in core drill rig for floors. Already have a drill? Tell us the model when you request a quote and we will check that the bit fits it.
Drill wet. Keep water running to cool the bit and keep silica dust down, and read the OSHA guidance on crystalline silica before you start. Scan slabs for rebar, conduit and post-tension cables before you core a floor.




