6 1/2 in Diamond Core Bit Rental in Brooklyn, NYC
The 6 1/2 in diamond core bit cuts a round hole about 6 1/2 in across through concrete, block, brick and stone on a core drill. It has 12 diamond teeth and a 15 3/4 in overall length. Rent it from our Brooklyn yard at 181 2nd Ave, or have it delivered with your drill anywhere in the five boroughs. Call 718-344-1474.
6 1/2 in core bit for a kitchen range hood
A Park Slope kitchen renovation adds a range hood that vents outside through the brick wall behind the stove. The hood takes 6 in round duct, and the exterior wall cap fits the same duct. A 6 in hole would be too tight, so a 6 1/2 in core leaves about 1/4 in all around for the duct, a sleeve or sealant.
Tip: Bigger hoods need more than a bigger hole. A hood that moves more than about 400 CFM usually needs a makeup air supply too, so ask your mechanical contractor before you buy the hood.
Is 6 1/2 in the right size?
Measure the outside of the pipe, duct or sleeve that has to fit, not the size printed on it. Then leave room for sealant, grout or firestop around it. In the job above, that works out to about 1/4 in each side.
- Bigger pipe or duct? Try the 8 in diamond core bit. Its usual job: yard storm drain through a foundation (6 in PVC, 6.625 in OD).
- Smaller pipe or duct? Try the 6 in diamond core bit. Its usual job: water service sleeve through a foundation (3 in ductile iron in a 5 in steel sleeve, 5.563 in OD).
- See every size and what it fits in our core bit size chart.
Specifications and Features
Rental Details
Which drill: for a bit this size, use a 36 in core drill rig or the 48 in EDCO rig (up to 8 in) for straight holes in slabs and thick walls. Already have a drill? Tell us the model when you request a quote and we will check that the bit fits it.
Drill wet. Keep water running to cool the bit and keep silica dust down, and read the OSHA guidance on crystalline silica before you start. Scan slabs for rebar, conduit and post-tension cables before you core a floor.




